Fold and Go Single Speed

Assembly instructions for Fold and Go Tricycle

1 Remove tricycle from box

2 Remove all packaging and inspect for damage

3 Insert front wheel into fork

   Assemble as follows

   A) Insert wheel into fork

   B) Insert safety washer into hole in fork

   C) Place round axle washer next to safety washer

   D) Tighten axle nut on both sides of wheel

   E) Push on black plastic axle nut caps

4 Attach front fender brace

5 Insert handlebar stem into fork and tighten lever on top of stem

   A) Note: Handlebar stem is marked with a minimum insertion mark

6 Insert seat post into frame

   A) Note seat pole is marled with a minimum insertion into frame mark

7 Install rear basket

   A) Put basket bolts thought basket and frame and tighten nut on bottom of bolt

8 Check air pressure in tires

   A) Air pressure is marked in side wall of tire

9 Inspect for safety before riding

   A) Brakes make sure they stop properly

   B) Handlebar stem and handlebar make sure they are tight

   C) Seat and seat post make sure it is tight

   D) Nuts on all three wheels are tight

   E) Check pedals to make sure they are tight

Trouble shooting

Front brake is not stopping properly

A)    Check brake pad to rim clearance

B) Check to see if brake center bolt is to tight

C)    Check to see if cable moves thought housing freely

D)    Check to see if brake handle does not bind

Head Set (To loose or to tight)

A)    Loosen top nut, tighten or loosen cone by hand, retighten top nut with wrench

Rear wheel do not spin well

A) Nut on out side of wheel is to tight and binding bearing, loosen outside nut slightly